Arlon DPF White Ultra Tack Arlon’s DPF is a 90 micron, satin white, high-tensile, PVC film with aggressive, permanent adhesive. Designed to stick to . The ultimate premium film for hard to stick surfaces. A durable film combined with a high tack adhesive system allows you to use one film for all your difficult. “We use Arlon DPF every day because of its durability and price point. We wrap a lot of brick walls and needed something that would hold up in heavy.
|Published (Last):||11 August 2007|
|PDF File Size:||20.85 Mb|
|ePub File Size:||7.74 Mb|
|Price:||Free* [*Free Regsitration Required]|
For this reason, an edge seal is recommended for applications that have very rough surfaces. Where it is practical, two people on the removal make the job go far faster than using just one.
Arlon DPF White Ultra Tack
Printed durability is dependent on the ink system used. If the surface is not sealed there must be no loose paint, grit or chalk present. When printing this product be vigilant about drying the finished decal completely before laminating, top coating or installing. We do not recommend wrapping gasoline tanks or similar plastics exposed to like fumes.
Moisture cannot wick to the adhesive surface from within the matrix of the wall. Graphics Removal Remove the film in a continuous smooth motion at a shallow angle for the fastest separation.
Removal steps are much easier 8000 the adhesive will remove more cleanly and if any adhesive remains, the surface will be cleaned of residue more easily. For many polyolefinic surfaces, once the oily skin of the plastic is modified arlkn will improve dramatically.
With one person working the heating unit in front of the second person who is peeling film, the job proceeds at a uniform and consistent pace.
DPF 8000™ Ultra Tack
Sealing porous surfaces creates three benefits: The film installs best on epf surfaces when processed and applied according to Arlon recommendations. Because of the porous nature of all masonry and its general roughness, Arlon does expect water, snow or ice to seep between the film and wall and collect on the upper edges of the applied graphic.
Concrete, Masonry, and Tile The surface should be entirely dust free: Plastic These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame. Where only one person is working there will be constant starting and stopping in addition to the problems of the heat being very inconsistent.
Dust due to ablation cannot develop under the vinyl. Arlkn here to see the WrapItRight video: These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame. Rough surfaces may not carry the standard warranties. The surface should be entirely dust free: Application in cold temperature environments.
As a result, arlom is best practice to not leave the printer unattended when printing to avoid headstrikes due to adhesive build up on the film edges over time. Addition of heat during removal will make the process much cleaner alron faster. Remove the film in a continuous smooth motion at a shallow angle for the fastest separation. Due to the porosity of certain types of plastics i. PP, PEplastics exposed to gasoline from tanks will migrate through plastic and interfere with vinyl adhesion to the plastic.
This is contingent upon no rain or harsh outdoor weather conditions. Standard warranty applies to vertical applications only. Special Considerations Because of the porous nature of all masonry and its general roughness, Arlon does expect water, snow or ice to seep between the film and wall and collect on the zrlon edges of the applied graphic.
The trade-off for high tack and adhesion is to expect higher visible shrinkage than normal.
To assure highest adhesion the graphics will benefit from a final installation pass using arrlon soft roller and heat source in combination. The film should be heated to a point of softening. Non-vertical applications are not warranted for this product. The surface must be sealed with a complete coat of paint or concrete sealer and allowed to dry.