Arlon DPF White Ultra Tack Arlon’s DPF is a 90 micron, satin white, high-tensile, PVC film with aggressive, permanent adhesive. Designed to stick to . The ultimate premium film for hard to stick surfaces. A durable film combined with a high tack adhesive system allows you to use one film for all your difficult. “We use Arlon DPF every day because of its durability and price point. We wrap a lot of brick walls and needed something that would hold up in heavy.
|Published (Last):||18 January 2008|
|PDF File Size:||13.40 Mb|
|ePub File Size:||16.32 Mb|
|Price:||Free* [*Free Regsitration Required]|
Printed durability is dependent on the ink system used. This is contingent upon no rain or harsh outdoor weather conditions. These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame.
Plastic These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame. Dust due to ablation cannot develop under the vinyl. With one person working the heating unit in front of the second person who is peeling film, the job proceeds dpg a uniform and consistent pace.
Where only one person is working there will be constant starting and stopping in addition to the problems of the heat being very inconsistent.
If the surface is not sealed there must be no loose paint, grit or chalk present. The film d;f best on flat surfaces when processed and applied according to Arlon recommendations.
DPF 8000™ Ultra Tack
The surface must be sealed with a complete coat of paint or concrete sealer and allowed to dry. As a result, it is best practice to not leave the printer unattended when printing to avoid headstrikes due to adhesive build up on the film edges over time. PP, PEplastics exposed to gasoline from tanks will migrate through plastic and interfere with vinyl adhesion to the plastic. Non-vertical applications are not warranted for this product.
Sealing porous surfaces creates three benefits: When printing this product be vigilant about drying the finished decal completely before laminating, top coating or installing. The film should be heated to a point of softening. For this reason, an edge seal is recommended for applications that have very rough surfaces. Moisture cannot wick to the adhesive surface from within the matrix of the wall.
Standard warranty applies to vertical applications only. Graphics Removal Remove the film in a continuous smooth motion at a shallow angle for the fastest separation. Addition of heat during removal will make the process much cleaner and faster.
DPF ™ Ultra Tack Technical Details | Arlon Graphics
Due to the porosity of certain types of plastics i. Special Considerations Because of the porous nature of all masonry and its general roughness, Arlon does expect water, snow or ice to seep between the film and wall and collect on the upper edges of the applied graphic. The surface should be entirely dust free: Concrete, Masonry, and Tile The surface should be entirely dust free: Removal steps are much easier as the adhesive will remove more cleanly and if any adhesive remains, the surface will be cleaned of residue more easily.
Click here to see the WrapItRight video: Remove the film in a continuous smooth motion at a shallow angle for the fastest aroln. Because of the porous nature of all masonry and its general roughness, Arlon does expect water, snow or dfp to seep between the film and wall and collect on the upper edges of the applied graphic.
Where it is practical, two people on the removal make the job go far faster than using just one. For many polyolefinic surfaces, once the oily skin of the plastic is modified bond will improve dramatically. Rough surfaces may not carry the standard warranties.
Application in cold temperature environments. We do not recommend wrapping gasoline tanks or similar plastics exposed to like fumes. The trade-off for high tack and adhesion is to expect higher visible shrinkage than normal. To assure highest adhesion the graphics will benefit from a final installation pass using a soft roller and heat source dpc combination.